Utilization of Solar Energy
1.Solar Collector
Heat pipe collectors using heat tube as heating elements, form a complete set of special collector, mainly for the central hot water system, fission hanging water heater, swimming pool heating, solar heating, solar part of the villa product, high thermal efficiency, product reliability.
2.Solar hot water tank storage system
Product features:
1) The special enamel benchmark for carbon steel water tank, water tank with a large area of heat transfer of steel coil heat.
2) Bladder and hot coil in accordance with the German industrial standards DIN4753 Teil3 enamel, external spraying antirust paint.
3) According to the German industrial standards DIN4753 Teil6 USES a magnesium rod protection, ensure that the tank use for a long time do not corrode.
4) Water temperature probe with the mobile body external fixation.
5) Equipped with a electric heating interface.
6) With 150 mm flange observation hole.
7) Tank outer 50 mmpu thermal insulation layer, according to the German industrial standards DIN4753 Teil8 request production.
8) Water bravery inside enamel material for the import of American fortune in enamel.
Product performance and advantages:
1)Coil layout is reasonable.
2)Large heat transfer area, high thermal efficiency.
3)Hot water is clean sanitation, drinking water standards.
4)Heat source for solar energy, electric heating tube for auxiliary heating.
3.Hot Water Circulating Pump
1) Places and conditions of use: used in homes, factories, units, water heaters, solar energy, mechanical equipment and so on.
2) Conveying pressure and circular thin, clean, the corrosion of explosive liquid.
3) Not containing solid particles, fibers and mineral oil, water and other liquids, the temperature of the liquid pump is in the range of 0-110 degrees.
4) Note: this pump water or liquid lubrication, so without water or liquid in the state of operation shall not exceed 10 seconds.
5) Four points with six points in the pump parts, to prevent foreign matter into the pump, affect the service life, suggest adding filters.
4.Solar Powered Systems Holder
1)Product introduction: solar photovoltaic stents, pv stent accessories.
2)Material: stainless steel 201, 304, Q325.
3)The production process: stamping, welding, surface passivation, shot blasting treatment. Q325 galvanized surface.
4)Usage: photovoltaic power station on the ground, roof solar energy components of fixed and support.
5)Installation site: the ground station or flat roof solar modules installed
5.Introduction characteristics of the solar system:
1)Patent vacuum tube: global initiative, independent research and development, UTLE (ultra low emission) technique to build the polar cold tube, reduced emission than the unprecedented, cold resistance, antifreeze.
2)Conquer the vacuum tubes heat dissipating high general problem, overnight or rainy days out of the hot water as usual.
3)Patent interference coating technology to build a "three highs" vacuum tubes, composite heat increase, high temperature resistance, cold resistance, high efficient absorption, fully meet the needs of multiplicity the domestic hot water.
4)With thick insulation layer: the automatic thermostatic quantitative disposable foaming process of high pressure thickening insulating layer.
5)And after high temperature curing processing. Uniform density, hot slow attenuation, stable performance, good heat preservation effect.
